Stainless Steel Tubular Electric Heater Function Description
Darui Electric recommends for you
Working voltage allowable error: not greater than 1.1 times its rated value, the shell should be effectively grounded.
Working environment: relative humidity not greater than 95%, no explosive and corrosive gases.
In the dimension diagram, “B” must be fully immersed in oil (and checked regularly) to avoid burning, the heated oil should be non-corrosive. When melting solid oils such as asphalt and paraffin, reduce the voltage during use, and then increase to the rated voltage after melting. To prevent heat concentration and reduce the service life of the element. Keep the outlet end dry and clean to avoid surface flashover or short circuit. The element should be stored in a dry place. If the insulation resistance drops below 1MΩ due to long-term storage, it can be dried in an oven at about 200°C for several hours (or apply low voltage to the element for several hours) to restore the insulation resistance.
SRY2 type mounting hole size is Φ65mm, working pressure is 6kg/cm2
Application: SRY2 ordinary tubular electric heater is suitable for heating oil in open or closed oil tanks, and can also heat water and other media with better heat transfer than oil. Suitable for heating oil in circulation systems.
Note: The above information and technical parameters are compiled and released by Yangzhou Darui Electric Co., Ltd.
